New version stuck while scanning.

  • Hello Just now updated Wordfence plugin to newer version 6.2.9 and it’s stuck while scanning then I downgraded to v6.2.8 and now scanning process is working fine.

    My Site

    Thanks

Viewing 2 replies - 1 through 2 (of 2 total)

  • Hello,
    Please check these common reasons for the “Scans don’t finish” problem, if none of these helped, then please go to (Wordfence > Diagnostics) and scroll down the page then choose “Enable debugging mode“, after that go to (Wordfence > Scan) and click on “Start a Wordfence Scan”, paste any errors you may get here to check and don’t forget to turn off the “debugging mode” after you finish this process.

    Thanks.

    Thread Starter buyacsgo

    (@buyacsgo)

    Hello @wfalaa thanks for the response and sorry for my later response as I was downgraded my plugin version.

    So, I upgraded today and started a new scan, first time scan was completed. After 20 minutes later I have started a another scan to check, that 2nd scan wasn’t completed. So, I cancelled that scan manually.

    After Adjusting the max execution time (Maximum execution time for each scan stage” to 15 seconds) I started a new scan and scan was completed successfully and it took 3 minutes 40 seconds to complete. I will check again after 20-30 minutes later and will update you shortly.

    Thanks & Regards,
    Buyacsgo

    • This reply was modified 8 years, 2 months ago by buyacsgo.
    • This reply was modified 8 years, 2 months ago by buyacsgo.
    • This reply was modified 8 years, 2 months ago by buyacsgo.
Viewing 2 replies - 1 through 2 (of 2 total)
  • The topic ‘New version stuck while scanning.’ is closed to new replies.