Crawler stuck on start watching

  • Hi Litespeed,

    I can’t get the crawler to work, I’ve tried lowering the delay etc but it seems to be stuck. I’ve tried a few of the other suggestions i’ve read in the forum but to no success. In the crawler status it just says start watching. The service code is: AFDGWKTI

    Thanks

    • This topic was modified 2 days, 14 hours ago by deanodino1.
Viewing 5 replies - 1 through 5 (of 5 total)
  • Plugin Support qtwrk

    (@qtwrk)

    try set interval to , at least 61 , or better 300 seconds or more

    did manual start work ?

    Thread Starter deanodino1

    (@deanodino1)

    Thanks for responding. I’ve changed all of the settings, both increasing and decreasing them but nothing seems to work. I have set the interval to 300. when I click manual start, the page refreshes but nothing happens – start watching is always displayed

    Plugin Support qtwrk

    (@qtwrk)

    go to debug setting , set debug to ON , debug level to advance , debug include URI, add litespeed_type= into that field , save

    then go to log view section ,clean up any existing log

    then wait for 5 minutes , manual start it , if nothing happens , wait for another 5 minutes , manual start it again , then go to log view , share me the debug log it generates

    Thread Starter deanodino1

    (@deanodino1)

    Thanks for this, its helped me find the issue. It seems that Hide My WP is blocking the crawler and caching. What could be the issue?

    Plugin Support qtwrk

    (@qtwrk)

    eh? I am not sure , perhaps you can check with hide my wp support ?

    in our case, we need to have access to admin-ajax.php

Viewing 5 replies - 1 through 5 (of 5 total)
  • You must be logged in to reply to this topic.

Tags