Error: Bad Request missing parameter: ‘code’

  • Resolved freedosh

    (@freedosh)


    1 year ago

    Error: Bad Request

    missing parameter: ‘code’

    Hi, I’ve added sitekit to my wordpress shared host install, and tried to connect it multiple times; I keep getting this error. I’ve reset and reinstalled a few times. I’m not sure what to do.

    • This topic was modified 1 year ago by freedosh.

    The page I need help with: [log in to see the link]

Viewing 4 replies - 1 through 4 (of 4 total)
  • Thread Starter freedosh

    (@freedosh)

    I figured it out. Can’t use Brave. Even with shield turned off; switched to Edge and it connected.

    Plugin Support Adam Dunnage

    (@adamdunnage)

    @freedosh Nice troubleshooting! Glad to hear you found and resolved your issue. I will mark this topic as resolved. If you do have any further issues or questions about Site Kit then please feel free to open a new support topic and we will be happy to help!

    Asif

    (@asif_rn)

    Why not in Brave…???

    Plugin Support Adam Dunnage

    (@adamdunnage)

    @asif_rn This is a known issue with the Brave browser. This is caused by a?setting in the Brave browser?which is switched on by default causing this error and stopping you from setting up Site Kit.

    If you are using the Brave browser then you will need to switch this setting off to complete Site Kit setup. This will also stop you connecting any of the modules within Site Kit if this setting is switched back on.

    If you continue to run into issues then please feel free to open your own support topic with us and we will be happy to help you.

Viewing 4 replies - 1 through 4 (of 4 total)
  • The topic ‘Error: Bad Request missing parameter: ‘code’’ is closed to new replies.